Floppy Disk

In the below illustration we have represented what a floppy cable may look like. In the below illustration this floppy cable allows a desktop computer to have two floppy drives connected to one controller like the IDE / EIDE controller. Because floppy drives almost always do not have a master / slave jumper, the drives are defined by cable select, which can be identified by looking for the cable twist as shown below.

Originally created in 1967 by IBM, the floppy reference is derived from the floppy media that is encased within the protective casing. This media is a magnetic medium and is written to much like the method used by hard disk drives. Floppy drives have been found in computers for several years and are commonly still being used today. The next generation of floppy drives will more than likely be the LS-120 diskette drives which are already being included in many computers now.

8" Disk - The first disk was introduced in 1971. The disk was 8" in diameter with a magnetic coating, enclosed in a cardboard case with the capacity of one megabyte. Conversely to hard disks, the heads actually touch the disk, like in a cassette or video player which actually wears the media. 5.25" Disk - 160KB first Created in 1976 and later becoming a standard in 1978. 5.25" Single Side - 160KB, 5.25" Double Side - 360KB, 5.25" Double Side High Density - 1.2MB. 3.5" Disk - Created by IBM in 1984, which even today are still commonly used. Most 3 1/2" newer disks have a capacity of up to 1.44MB. 3.5" Double Density - 720KB, 3.5" High Density - 1.44MB, 3.5" Extended Density (IBM ONLY) - 2.88MB

First, the top left of the back of the floppy there is a small tab. This tab enables the floppy disk to be switched from write protected and un-write protected. Move the tab to the top position, creating a hole, makes the disk write protected. This means that nothing can be written, erased or deleted from the diskette. Moving the tab to the bottom position allows the disk to be un-write protected, which means the diskette can be written too, erased, and or have information deleted from the diskette. Some diskettes, which are generally cheaper diskettes, will be missing this tab. To write information to the diskette you will have to place a piece of scotch tape over the hole.

Second, the top right hand of the back of the floppy you will notice a small hole. This tells the computer if the diskette within the computer is a High Density diskette.Third, you will notice the circular metal disk in the middle of the floppy diskette. This is used to rotate the magnetic medium within the floppy disk casing.Fourth, you will see a metal door which can be moved left and then will snap back to its original position. This door is used to allow the read/write head within the floppy drive to have the capability of accessing the magnetic medium within the casing. Once the diskette is removed, this door will snap back into position, helping to prevent anything from getting on the magnetic medium and destroying it.